88 PX4i and PX6i High Performance Printer User Guide
Fingerprint Error Messages
Message Description Ready-to-Work
Indicator
Status
Error
Number
Out of paper The printer is out of paper. Load a new roll of media. For help, see
"Loading Media" on page 5.
Blinking 1005
Next label not
found
Next label not found Blinking 1031
Label not taken Label not taken Blinking
Out of transfer
ribbon
The printer is out of transfer ribbon. Load a new roll of ribbon. For
helps, see "Loading Ribbon" on page 38.
Blinking 1027
Transfer ribbon
is installed
This is not an error condition. This message briefly appears after a
new roll of transfer ribbon is installed.
Blinking 1058
Head lifted The printhead is lifted. Lower the printhead. Blinking 1022
Cutter does not
respond
Open and shut the cutter. Blinking 1059
Cutter error1 Open and shut the cutter. Blinking 1701
Cutter error2 Open and shut the cutter. Blinking 1702
Cutter error3 Open and shut the cutter. Blinking 1703
Cutter open Shut the cutter. 1704
LSS too high This error can occur when you run a test feed without any media
installed, or if you have incorrect media settings. Load the printer
with media and select the appropriate media type. For help, see
"Loading Media" on page 5.
Blinking 1007
LSS too low This error can occur when you run a test feed without any media
installed, or if you have incorrect media settings. Load the printer
with media and select the appropriate media type. For help, see
"Loading Media" on page 5.
Blinking 1008
Testfeed not
done
The printer did not perform a test feed before it printed out test
labels. Performing a test feed calibrates the sensor. To perform a
testfeed, press the button.
Blinking 1606
No RFID support
installed
The optional RFID interface is not installed in the printer. Blinking 1320
No tag found No RFID tag has been found. Blinking 1321
Pause Mode
Entered
The print job is paused. Blinking
Setup Mode
Entered
The printer is in Setup mode. Off
IP link error No network connection. Blinking
IP configuration
error
The printer is trying to acquire an IP address from the network.
Wait for the printer to complete the task before taking any action.
Blinking
Generic DP error In Direct Protocol, you can enable error handling for specific
errors using the ERROR statement. When errors added to the
built-in error handling occur, this event is set. The text included in
the SNMP trap is the standard text corresponding to the error.
Blinking
To Next Page
Loading...
Need help?
General
