PX4i and PX6i High Performance Printer User Guide 95
4. Quickly press the following keys in sequence:
5. The following message appears:
Factory Default?
Enter=Yes ESC=No
6. Within 10 seconds, press to reset the printer to its factory default settings.
The parameters are reset and the printer continues the normal startup process.
7. If you do not press within 10 seconds, the normal startup continues and
the printer is not reset.
Adjusting the Printer
You may need to adjust your printer to accommodate your printing needs or
improve performance. You can adjust the:
•pressure arm.
• label stop sensor (LSS) position.
• printhead pressure.
• label taken sensor.
Adjusting the Pressure Arm
The printer is factory-adjusted for full-size media width. If you are using media that
is less than full width, Adjust the position of the pressure arm so that it is centered
on the media and provides even pressure.
A poorly adjusted pressure arm may be detected by a weaker printout on either side
of the media path.
To adjust the pressure arm
1. Turn off the printer.
Enter
Enter
To Next Page
Loading...
Need help?
General
