6 PX4i and PX6i High Performance Printer User Guide
• Cut-off
• Batch take-up
•External supply
•RFID
If you are using Fingerprint, use the key to load the same type of media. If you
change the media type, or if the printer does not feed the media properly, simulta-
neously press the and keys to perform a “testfeed.”
If you are using IPL, save the label with the sensitivity number attached to the
media roll. You need this number to set the media sensitivity.
Loading Media for Tear-Off Printing
In tear-off, or straight-through, printing mode, you manually tear off the media
against the printer’s tear bar. In tear-off mode, use these types of media:
• Non-adhesive continuous stock
• Self-adhesive continuous stock with liner
• Self-adhesive labels with liner
• Tickets with gaps (gap stock), with or without perforations
• Tickets with black marks (mark stock), with or without perforations
You can also install an optional label taken sensor so that the next copy in the
batch is not printed until the current copy is removed. For more information, see
"Accessories for the Printer" on page 124.
If you are running Fingerprint, use the key to load the same type of media. If
you switch to a new type of media, or if the printer does not feed out the media
properly, simultaneously press the and keys to perform a “testfeed.”
If you are running IPL, save the label indicating the sensitivity number attached to
the media roll. You need this number to set the media sensitivity.
To load media for tear-off printing
1. Turn off the printer.
Feed
Shift
Feed
Feed
Shift
To Next Page
Loading...
Need help?
General
