82 PX4i and PX6i High Performance Printer User Guide
Each time the Avalanche Enabler is activated (typically on a warm boot), the printer
attempts to connect to the Avalanche Agent. When the printer connects to the
Agent, the Agent determines whether an update is available and immediately starts
the software upgrade, file transfer, or configuration update.
To use Avalanche to remotely manage the printer
1. Install the configuration updates for the printer using the Avalanche Adminis-
trative Console.
2. Schedule the printer updates or manually initiate an update using the
Avalanche Administrative Console.
For more information on using Wavelink Avalanche, contact your local Honeywell
representative or visit the Wavelink website at www.wavelink.com.
Choosing an Ethernet or Wireless Network
If you have an 802.11 wireless radio option installed in your printer, you need to
choose between an Ethernet network or a wireless 802.11 network.
You can choose the network type of your printer:
• directly from the screen.
• using commands sent from your PC.
• using SmartSystems Foundation. For help, see "Configuring Your Printer Using
SmartSystems Foundation" on page 81.
• from the printer home page. For help, see "Configuring the Network Type" on
page 74.
• using PrintSet. For help, see "Configuring Your Printer With PrintSet" on
page 80.
Choosing the Network Type From the Printer Screen
To configure the printer from the screen, you need to enter Setup mode.
To choose the network type from the printer screen
1. Press to enter Setup mode.
2. Navigate to Network > Network Type and press .
3. Select either Ethernet or Wireless 802.11 and press .
4. Press to exit Setup mode.
5. Reboot the printer for the change to take effect.
Enter
To Next Page
Loading...
Need help?
General
