74 PX4i and PX6i High Performance Printer User Guide
Use the following table to understand the TCP/IP settings.
Configuring the Network Type
Use the Network Type page to choose whether you are using an Ethernet or wire-
less 802.11 network.
Setting Description
IPV4 Settings Configuration method: The method by which an IP address is assigned to the
printer. You can choose between DHCP, BOOTP, DHCP+BOOTP, or MANUAL.
Address: The current IP address of the printer.
Netmask: Manually assigned netmask for the printer.
Default Router: The IP address of the default router.
IPV6 Settings Configuration method: The method by which an IP address is assigned to the
printer. You can choose between:
• AUTO: The IP address is obtained using stateless auto-configuration. This
is the default configuration method.
• AUTO+DHCP: The IP address is obtained using stateless auto-
configuration, but DNS options are obtained using DHCP.
• DHCP: The IP address and DNS options are obtained using DHCP.
• MANUAL: The IP address is set to a static address that you enter in the
Static Address field.
Current addresses: A list of all the currently configured IP addresses for the
Ethernet interface. The address starting with FE80:: is the link-local address
and is available regardless of the configuration method you choose.
Static address: This address applies if you selected manual as the
configuration method. The IP address
is specified as an address and a prefix separated by a slash. You can use “::” to
represent a large number of consecutive zeros. You should typically set the
prefix to 64.
Example:
2001:DB8:0:F101::2/64
Name Resolution DNS Server: The IP address of the name server.
DNSv6 Server: The IP address of the name server for IPv6.
WINS Server (Primary and Secondary): The IP addresses of the primary and
secondary WINS servers. If you chose DHCP or BOOTP for the configuration
method, you may see the currently assigned WINS IP addresses depending on
the configuration of your DHCP server.
Printer Service NET1 TCP Port Number: The port number for raw TCP. The default is 9100.
NET1 Queuing: Determines whether queuing for the TCP port is turned on, off,
or enabled for multiple network connections (Multi).
To Next Page
Loading...
Need help?
General
