To Next Page

To Previous Page

60 PX4i and PX6i High Performance Printer User Guide

• Send the following commands to set a common name for server 1 and server

<STX><SI>ws,.SERVER_CN1,xxxxxxxxxx<ETX>

<STX><SI>ws,.SERVER_CN2,xxxxxxxxxx<ETX>

where xxxxxxxxxx is at least 8 characters but less than 96

characters.

• Send the following command to make sure your values match those used by

the access point:

All variables are returned with the exception of EAP_PASS which always returns

“****” if configured and CA_CERT which transmits the name of the last certificate

authority successfully installed. An additional read-only variable for the supplicant

state, called STATE, is also returned.

• You may need to send the following command several times for the wireless

station to connect:

<STX><SI>ws,ACTIVE,1<ETX>

Connecting Peripherals to the USB Host Port

You can connect these peripheral devices to the USB host interface port on the

printer:

•USB mass storage device

•Keyboard

• Bar code scanner

•USB hub

Using a USB Mass Storage Device

You can use a USB mass storage device (thumb drive) to store additional fonts and

images for the printer. You can also use the device to upgrade your firmware. For

more information on using the USB mass storage device to upgrade the printer,

see "Upgrading Firmware" on page 83.

To verify the USB storage device is supported by your printer, insert the USB stor-

age device in the appropriate slot on the back of your printer. On the display screen,

one of the following status messages briefly appears:

• USB memory stick connected

• USB memory stick not supported

If no status message appears when you insert the USB storage device, you can

manually verify the USB storage device is supported using HyperTerminal.

Honeywell PX4i User Manual

Questions and Answers: