MEDIA CONTROL Submenus
127
MEDIA CONTROL Submenus
Print Intensity
This option specifies the level of thermal energy from the printhead to be used
for the type of media and ribbon installed.
Large numbers imply more heat (thermal energy) to be applied for each dot.
This has a significant effect on print quality. The print intensity and speed
must match the media and ribbon type to obtain the best possible print quality
and barcode grades.
The range is -15 through +15.
The factory default is -3.
Peel-Off Mode
1
Fast* Standard
Continuous Mode
2
Standard* Tear-Off
TOF Detect Fault
3 Labels* 9 Labels
Tear Strip Full
Ticket Save Mode
Disable* Enable
1 Label
MEDIA CONTROL
(cont. from previous page)
Notes:
* = Factory Default
Italicized items are available only when Admin User is set to Enable (in
the PRINTER CONTROL menu).
1
The Peel-Off option under Media Handling must be enabled for this
menu to function.
2
The Continuous option under Media Handling must be enabled for
this menu to function.
3
In increments of 0.01 inch.
TOF Adjust Mode
Disable* Enable
TOF Adjust
0.00 to 0.40 Inches
3
To Next Page
Loading...
Need help?
General
