Overview
229
Last Char = FF
(From page 168, page 179.) Determines the print line position when a Form
Feed (FF) command is the last code encountered in the print buffer.
• On. Moves to the first print position on the second line of the next form.
• Off. Moves to the first print position on the first line of the next form.
NOTE: This option is ignored if Auto Skip At End is on.
If configured as a 3287, and a form feed occurs in the middle of a print buffer,
the printer defaults to the first print position on the second line of the next
form, regardless of the setting of this option.
The factory default is On.
Lead PDF Dist
(From page 186.) Adjusts the leading and trailing character spacing distance
of the PDF for UPC/EAN barcodes.
The range is 0.01- 0.10 inches in 0.01 inch increments, and the factory default
is 0.10 inches.
Lead-in Chars
(From page 168, page 170, page 180, page 182.) You can enable additional
printer features which are not accessible through standard coax emulations.
To access these features, send text commands in the data stream. The
commands must have a start and end code. Three sets (each containing a
start and end code) are available:
• Set 1 start code: <%
end code: >
• Set 2 start code:¬¬
end code: $
• Set 3 start code: _%
end code: _
The factory default is Set 1<%>.
Left Margin
(From page 190, page 193, page 195, page 197, page 199.)
Set in characters. Character zero is defined as the far left edge of the page,
and column numbering increments from left to right.
The range is 0-369 characters, and the factory default is 0 characters.
Emulation Submenus
To Next Page
Loading...
Need help?
General
