338
Appendix A
Media
Table 19. Media - General Information
Type: Roll-fed, die-cut continuous or fanfold labels, tags or tickets;
most direct thermal or thermal transfer materials.
Supply Roll: 8 inch (203 mm) maximum diameter on 1.5-inch (37.5 mm) to
3-inch (76 mm) diameter cores.
Internal Rewinder: Accepts up to a 5-inch diameter roll of label backing.
Label Material: Thermal transfer plain-coated papers, vinyl, Mylar, metallized
paper, non-woven fabric, fine woven fabric, thermal-visible light
scannable paper, infrared scannable paper, thermal ticket/tag
stock, thermally-sensitive plastic stock.
Media Sensing: Horizontally moveable sensor assembly. When set to Gap, the
assembly detects die-cut labels on liner media and notches and
holes in tag stock. When set to Mark, it senses a black mark on
the underside of tag or label stock. When set to Advanced Gap, it
detects liner gaps between die cut labels with a dark
background. When set to Advanced Notch, it detects notches or
holes that interrupt a dark or black area on the underside of the
media. When set to Disable, it senses no label indicators or
ignores all existing label length indicators on the installed media.
Label Taken Sensor: Detects when a printed label is at the printer exit throat. Used
only for Tear-Off and Peel-Off Media Handling modes.
Automatic Label Peel-Off: Peels and presents label to the operator, one at a time.
Automatic Label Peel-Off is supported only when the internal
rewinder is installed. (The internal rewinder is a factory- or
field-installed option.)
To Next Page
Loading...
Need help?
General
