IBM InfoPrint 6700 Series User Manual

6. U.S. Government Users
The Embedded Software is a "commercial item," as that term is defined in 48
C.F.R. 2.101 (Oct. 1995), consisting of "commercial computer software" and
"commercial computer software documentation," as such terms are used in
48 C.F.R. 12.212 (Sept. 1995). Consistent with 48 C.F.R. 12.212 and 48
C.F.R. 227.7202-1 through 227.7202-4 (June 1995), all U.S. Government End
Users acquire Covered Code with only those rights set forth herein.
7. Miscellaneous
This Agreement represents the complete agreement concerning subject
matter hereof. If any provision of this Agreement is held to be unenforceable,
such provision shall be reformed only to the extent necessary to make it
enforceable. This Agreement shall be governed by California law provisions
(except to the extent applicable law, if any, provides otherwise), excluding its
conflict-of-law provisions.
8. Red Hat Statement with regards to eCos Software
Part of the software embedded in this product is eCos - Embedded
Configurable Operating System, a trademark of Red Hat. Portions created by
Red Hat are Copyright (C) 1998, 1999, 2000 Red Hat, Inc.
(http://www.redhat.com) All Rights Reserved.
THE SOFTWARE IN THIS PRODUCT WAS IN PART PROVIDED BY RED
HAT AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT
NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY
AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO
EVENT SHALL THE AUTHOR BE LIABLE FOR ANY DIRECT, INDIRECT,
INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES
(INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE
GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR
BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY
OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT
(INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT
OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE
POSSIBILITY OF SUCH DAMAGE.

IBM InfoPrint 6700 Series Specifications

General

Brand	IBM
Model	InfoPrint 6700 Series
Category	Printer
Language	English

Summary

1 Introduction

Requesting IBM Service

How to request service for the printer, including contact information and procedures.

Warnings And Special Information

Safety precautions and important information for using the printer and protecting equipment.

Setting Up The Printer

Provides step-by-step instructions for unpacking and installing the printer.

2 Operation

Controls And Indicators

Identifies and explains the printer's controls, indicators, and the LCD display.

Powering On The Printer

Steps and expected behavior when powering on the printer for the first time.

Media Handling Modes

Describes the various modes for handling media, such as Continuous, Tear-Off Strip, and Peel-Off.

Loading Media And Ribbon

Instructions for loading different types of media and ribbons into the printer.

3 Configuring The Printer

Setting Printer Configuration Parameters

Explains how to set printer parameters via the control panel or memory.

Changing Printer Settings

Steps for modifying various printer settings like print speed and media handling.

Saving A Configuration

Instructions on how to save printer configurations for future use or as power-up defaults.

Modifying A Saved Configuration

Procedures for changing existing saved printer configurations.

Loading A Saved Configuration

Steps to load a previously saved printer configuration.

4 Interfaces

Auto Switching

Explains the Auto Switching feature for handling multiple data streams sequentially.

Centronics Parallel Interface

Details the Centronics parallel interface, including pin assignments and signals.

IEEE 1284 Parallel Interface

Explains the IEEE 1284 interface, its modes, and signals.

RS-232 And Optional RS-422 Serial Interfaces

Describes the RS-232 and RS-422 serial interfaces and their characteristics.

5 Diagnostics And Troubleshooting

Printer Tests

Guides on using printer tests to check operation and print quality.

Troubleshooting Common Situations

Lists common printer problems and their potential solutions.

Controlling Print Quality

Factors affecting print quality and how to adjust them.

Determining Printhead Wear

Methods to identify and diagnose printhead wear.

Replacing The Printhead

Step-by-step instructions for safely replacing the printhead assembly.

Restore The Printer To Operation

Fault Messages

Explains different fault messages and how to correct them.

Appendix D Heavy-Duty Media Cutter Installation

Prepare The Printer

Installing The Heavy-Duty Cutter

Detailed instructions for physically installing the heavy-duty media cutter.

Removing The Media Cutter