220
Chapter 3 Emulation Submenus
FF valid at TOF
(From page 191, page 198.) The FF valid at TOF option determines whether
the printer will perform a Form Feed when the host sends a Form Feed
command, if the printer is at the top of form.
• Enable. Performs a form feed when the host sends a Form Feed
command and the printer is at the top of form.
• Disable. Will not perform a form feed when the host sends a Form Feed
command and the printer is at the top of form.
The factory default is Enable.
FF Validity
(From page 168, page 179.) Determines if the position of a Form Feed (FF)
command affects its execution.
• Off. Performs a form feed only if it occurs at the first print position in a line
or at Maximum Print Position +1. An FF command at any other position is
recognized as a blank.
• On. Allows the printer to perform an FF command anywhere in the data
stream.
The factory default is Off.
Form Length (in.)
(From page 192, page 194, page 196, page 198, page 200.)
Form length is the number of lines that can be printed on a label. You can set
forms length in inches.
The factory default is shown in Table 3 on page 130.
Form Length (lines)
(From page 192, page 194, page 196, page 198, page 200.)
Form length is the number of lines that can be printed on a label. You can set
forms length as a function of the current LPI (lines per inch).
The factory default is shown in Table 3 on page 130.
Form Length (mm)
(From page 192, page 194, page 196, page 198, page 200.)
Form length is the number of lines that can be printed on a label. You can set
forms length in millimeters.
The factory default is shown in Table 3 on page 130.
To Next Page
Loading...
Need help?
General
