Step 1540-17
1. If it is not already off, turn off the power.
2. Remove all adapters from slots 5, 6, and 7 that are not attached to the boot device.
3. Label and record the location of any cables attached to the adapters.
4. Record the slot number of the adapters.
5. Turn on the power.
6. When the TTY screen displays Enter 0 to select this console, press the 0 key
on the TTY terminal’s keyboard.
Was the boot successful?
No Go to “Step 1540-14” on page 124.
Yes Go to “Step 1540-20” on page 126.
Step 1540-18
1. If it is not already off, turn off the power.
2. Remove all adapters from slots 9 and 10 that are not attached to the boot device.
3. Label and record the location of any cables attached to the adapters.
4. Record the slot number of the adapters.
5. Turn on the power.
6. When the TTY screen displays Enter 0 to select this console, press the 0 key
on the TTY terminal’s keyboard.
Was the boot successful?
No Go to “Step 1540-15” on page 124.
Yes Go to “Step 1540-20” on page 126.
Step 1540-19
1. If it is not already off, turn off the power.
2. Remove all adapters from slots 11, 12, 13, and 14 that are not attached to the boot
device.
3. Label and record the location of any cables attached to the adapters.
4. Record the slot number of the adapters.
5. Turn on the power.
6. When the TTY screen displays Enter 0 to select this console, press the 0 key
on the TTY terminal’s keyboard.
Was the boot successful?
No Go to “Step 1540-22” on page 126.
Yes Go to “Step 1540-20” on page 126.
Chapter 3. Maintenance Analysis Procedures 125
To Next Page
Loading...
Need help?
General