IBM S85 pSeries 680 User Manual

Service Processor Checkpoints
If you replace FRUs or perform an action, and the problem is still not corrected, go to
“MAP 1540: Minimum Configuration” on page 117 unless otherwise indicated in the
tables.
If you replace FRUs or perform an action, and the problem is corrected, go to MAP
410: Repair Checkout in Diagnostic Information for Multiple Bus SystemsDiagnostic
Information for Multiple Bus Systemsunless otherwise indicated in the tables.
Service processor checkpoints are in the range E010 to E0FF. The message OK
indicates successful service processor testing and initialization. Firmware checkpoints
are listed in “Firmware Checkpoints” on page 142.
Table 2. Service processor Checkpoints
Checkpoint Description Action/ Possible Failing FRU
E010 Starting service processor self-tests 1. Service processor card.
Location: U0.1-P1-X1
AIX Location Code: 10-70 or
10-70 to 10-77 1E-xx
2. I/O planar in primary drawer.
Location: U0.1-P1
E012 Beginning to set up service
processor heaps
Service processor card.
Location: U0.1-P1-X1
E020 Configuring CMOS 1. I/O planar in primary drawer.
Location: U0.1-P1
2. Service processor card.
Location: U0.1-P1-X1
E021 Configuring NVRAM 1. I/O planar in primary drawer.
Location: U0.1-P1
2. Service processor card.
Location: U0.1-P1-X1
E040 Configuring service processor I/O 1. Loose or missing JTAG cable
from service processor to system
rack
2. Service processor card.
Location: U0.1-P1-X1
3. I/O planar in primary drawer.
Location: U0.1-P1
E042 Configuring modem on serial port 1 1. Modem.
2. Service processor card.
Location: U0.1-P1-X1
3. I/O planar in primary drawer.
Location: U0.1-P1
4. Go to “Entry MAP” on page 79.
140 Service Guide

IBM S85 pSeries 680 Specifications

General

Brand	IBM
Model	S85 pSeries 680
Category	Server
Language	English