Fast Power Up Feature
Note: This feature is only recommended in a service environment because several key
system functions are not verified.
The fast power up sequence is as follows:
1. Press the system power pushbutton two times to ensure the power is off.
2. Press the Scroll Up pushbutton one time.
3. Press the Enter pushbutton two times.
4. Press the Scroll Up pushbutton two times.
5. Press the Enter pushbutton one time.
6. Press the system power pushbutton one time
The system powers up, and the system-operator panel displays progress indicators.
Covers
Before performing these procedures, read “Safety Notices” on page xiii.
Removal
Refer to “Operator Panel, Brackets, and Covers (Front View)” on page 544 and “Front,
Rear, and Top Covers” on page 540 to locate cover parts. Then perform the following
steps:
v To remove the front and rear covers, do the following:
1. Lift up on the cover.
2. Pull the cover out and off.
v To remove the top cover, do the following:
1. Remove the cover mounting screws.
2. Slide the cover to the front or rear.
3. Lift the cover up and off.
v To remove the side cover(s), do the following:
1. Remove the front, rear, and top covers.
2. Remove the screws from the front and rear of the side cover.
3. Lift up on the cover.
4. Pull the cover out and off.
Replacement
Replace in reverse order.
494 Service Guide
To Next Page
Loading...
Need help?
General