3. Replace the two screws that attach the drawer to the rear of the rails in the rack.
4. Replace the four retainer screws to the front of the drawer.
5. Plug the ac power cords into the rear of the drawer.
6. Perform the procedure in “Powering On the System” on page 493.
10 EIA-Unit I/O Drawer Removal and Replacement Procedures
This section provides procedures that are specific to the 10 EIA-unit I/O drawer.
I/O Tray
Before performing these procedures, read “Safety Notices” on page xiii.
Removal
1. Remove the ac power cords from the rear of the drawer.
2. Make a note of where all cables are attached to the rear of the drawer and then
disconnect them.
3. Remove the access panel above the rear of the I/O tray.
4. Remove the screws that attach the I/O tray to the 10 EIA-unit I/O drawer.
5. Slide the tray out one to two inches. The internal cables will restrict the tray from
being removed at this point.
Chapter 9. Removal and Replacement Procedures 513
To Next Page
Loading...
Need help?
General