Appendix G. Modem Configurations
With hundreds of modems to choose from, and various modem programming
standards, configuring a modem for use with the Service Processor can be challenging.
The Service Processor is designed to place little demand on an attached modem,
thereby increasing the setup and connection success rates. Several sample modem
configuration files are supplied that work directly with your modem, or provide a good
starting point for a custom setup, if required.
Sample Modem Configuration Files
The sample modem configuration files are located in your service processor firmware
and in the /usr/share/modems subdirectory (if your server is using AIX) with the
following names. A listing of each file is included at the end of this appendix.
Generic Modem Configuration Files
AIX File Name SP Firmware File Name
modem_z_cfg modem_z_sp
modem_z0_cfg modem_z0_sp
modem_f_cfg modem_f_sp
modem_f0_cfg modem_f0_sp
modem_f1_cfg modem_f1_sp
Specfic Modem Configuration Files
AIX File Name SP Firmware File Name
modem_m0.cfg modem_m0_sp
modem_m1.cfg modem_m1_sp
Use the following selection procedures and your modem manual to select a
configuration file that issuitable for your use.
Configuration File Selection
To select a modem configuration file, do the following:
1. Is your modem an IBM 7852-400?
If yes, use modem configuration file modem_m0_sp, and go to step 7 on page 620
below.
Note: The IBM 7852-400 modem has dip switches on the right side of the unit. See
“IBM 7852-400 DIP Switch Settings” on page 621 for the correct switch
settings.
© Copyright IBM Corp. 1999, 2000 619
To Next Page
Loading...
Need help?
General