----------------------------------------------------------------------
ProtecTIER Service Menu running on rasap1
Health Monitoring (...)
----------------------------------------------------------------------
1) Display health summary for this node
2) Display detailed health for this node
3) Run a full check on this node
4) Reset RSA/IMM
5) List open problems
6) Service Mode
B) Back
E) Exit
----------------------------------------------------------------------
>>> Your choice?
3. Type the numeral corresponding to Run a full check on this node and press
Enter.
A series of messages displays, reporting the system health states. Verify that the
following message appears:
Disk Array Health State is OK
What to do next
If you receive a message showing that the disk array state is configured correctly
(OK), proceed to “Prerequisites.” If you receive a message showing that the disk
array state is not configured correctly, contact your next level of support.
Prerequisites
Before configuring ProtecTIER, verify that the following tasks have been
completed:
v Cabling and physical connections (including connections to the local area
network (LAN) at the customer site, with assigned IP addresses) are complete.
See “Cabling a stand-alone appliance” on page 27, “Ethernet connections” on
page 50, or “Fibre Channel connections” on page 60 for additional information.
v TCP ports 3501 and 3503 (used by ProtecTIER Manager) are open in the firewall
at the customer site.
v If the customer plans to use replication, TCP ports 6520, 6530, 6540, 6550, and
6560 are open in the firewall at the customer site. Each ProtecTIER server being
used for replication must allow TCP access through these ports.
v Ensure that the applicable information is available for the IP address worksheet.
Refer to the Appendix B, “IP address worksheet,” on page 143 or the IP address
worksheet in the IBM System Storage TS7650 ProtecTIER Deduplication Appliance
and TS7650G Deduplication Gateway Introduction and Planning Guide, IBM form
number GA32-0918.
v You have collected the following information for each 3958 AP1 server:
– External IP address
– External and fully qualified host name (For example: hostname.domain.com)
– External default gateway address
– External network subnet mask
– Replication Port 1 IP address
– Replication Port 1 netmask
– Replication Port 1 host name (for example: jaguar_source_1)
102 IBM System Storage TS7650 ProtecTIER Deduplication Appliance: Installation Roadmap Guide
To Next Page
Loading...
Need help?
General