68
9
DATA OPERATION
New2001
9
■ Data transferring
NOTE: Set a fixed IP address, the same workgroup and a
shared folder for each PC, as well as the call sign setting
each other for direct data transferring between ID-1s. In
this case, the steps e, t to u are not necessary.
DD
Setting from the application
qClick [MODE] to select DD (Data mode).
•“DD” appears.
wSet the desired frequency.
eClick [RP] several times to select “RPS,” when connecting
the PC through repeater/s.
rClick [CS] to display the Select Call Sign screen, set your
call sign in “MY” then click [OK].
• Click [Y]/[Z] to select the programmed your call sign.
• When your call sign is not programmed, enter your call sign into
the text box directly.
tSet the desired station call sign in “YOUR” then click [OK].
• Click [Z] to select or enter the call sign into the text box directly.
For direct data transferring between ID-1s, go to step
ii
.
ySet the desired near-by repeater call sign in “RPT1,” if de-
sired.
• Click [Z] to select or enter the call sign into the text box directly.
uSet the gateway repeater call sign in “RPT2,” then [OK], if
desired.
• Click [Enable] (“✔” appears) to enable “RPT2” call sign setting.
• Click [Z] to select or enter the call sign into the text box directly.
• When the gateway repeater require the “G” setting, click [G].
NOTE:
When the near-by repeater is gateway repeater, set
the call sign into “RPT1” then click [OK], and skip step u.
• When the repeater requires the “G” setting, click [G].
iClick [TX inh] to release transmission inhibit.
• The transmit inhibit indicator (above [TX inh]) turns OFF.
• Starts accessing to the desired station (via repeater/s).
oOpen “Network Computers.”
• The shared folder of the desired station appears.
• It may takes a minutes until the shared folder appears according
to the conditions, or PC performance.
!0Open the shared folder, then drag and drop the desired file
to transferring.
!1Click [TX inh] again to disconnect (inhibit the transmission)
from the connected PC.
Set the desired
station call sign.
Set the gateway
repeater call sign.*
*if desired
Set the near-by
repeater call sign.*
Click if necessary.
Set your call sign.
ID-1_ENG_2.qxd 04.9.22 9:29 Page 68 (1,1)
To Next Page
Loading...
Need help?
General
