4 No External Devices
22-6 SmartAXIS Touch User's Manual
4.1 Overview
In this case, there is no communication with an external device, so the Touch operates as a standalone unit.
It is only possible to operate the Touch with relays and registers.
4.2 No External devices Settings
No external devices settings are selected on the Select Communication Driver dialog box, or the Change
Communication Driver dialog box.
• When creating new project data by following displayed dialog boxes and configuring settings step by step, by
clicking , and then clicking New, the Select Communication Driver dialog box is displayed. For details, refer
to Chapter 3 “Create new project data by using the interactive quick start” on page 3-1.
•Click Communication Driver on the status bar to display the Change Communication Driver dialog box. For
details, refer to Chapter 3 “Changing Communication Drivers” on page 3-15.
Select IDEC System in Manufacturer, and then select No External Device in Communication Driver.
4 No External Devices
Touch
Internal device
No external devices
To Next Page
Need help?
General
