EasyManuals Logo

jcb 215 Service Manual

jcb 215
890 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #68 background imageLoading...
Page #68 background image
17 - 1
Checking the Oil Level
1 Make sure the park brake is engaged and the
transmission set to neutral. Lower the loader arms and
backhoe to the ground, switch OFF the engine and
remove the starter key.
2 Open the bonnet, see Engine Panels, Opening and
Closing the Bonnet.
3 Switch OFF the engine and remove the starter key, fill
the gearbox to maximum mark on dipstick/filler A. Use
only the recommended oil.
4 Start and run the engine slowly for a period not
exceeding five minutes. This allows the oil to fill filter,
pump, torque converter, oil cooler and hoses.
5 Switch OFF the engine and remove the starter key, wait
approximately 20 seconds. Check the oil level and if
required, fill to dipstick level.
Section 3 Routine Maintenance
9803/3280
Section 3
17 - 1
Issue 2*
Powershift Gearbox
A405230
A
www.WorkshopManuals.co.uk
Purchased from www.WorkshopManuals.co.uk

Table of Contents

Other manuals for jcb 215

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the jcb 215 and is the answer not in the manual?

jcb 215 Specifications

General IconGeneral
Engine Power74 hp
Rated Operating Capacity2, 100 lbs
Lift PathVertical
Tipping Load4, 200 lbs
Net Engine Power74 hp
Width over Tires1, 800 mm
Height to Top of Cab2, 300 mm
Hinge Pin Height2, 800 mm
Travel Speed11 km/h
Travel Speed (High)11 km/h

Related product manuals