jcb 215 Service Manual

85 - 1
Removal and Replacement
(2 Wheel Drive Machines)
The removal and replacement procedures for the 2 wheel
drive axle (beam type) is the same as described on pages
F/80-1 and F/80-2. Dis-regard any information which is not
pertinent to the 2 wheel drive axle.
Please note when using a 'cradle' to remove the axle from
the machine, the balance point (see step 10, page F/80-2),
of the axle on 2 wheel drive machines will be the centre of
the axle, NOT offset as described on page F/80-2.
Section F Transmission
9803/3280
Section F
85 - 1
Issue 1
Front Axle
www.WorkshopManuals.co.uk
Purchased from www.WorkshopManuals.co.uk

jcb 215 Specifications

General

Engine Power	74 hp
Rated Operating Capacity	2, 100 lbs
Lift Path	Vertical
Tipping Load	4, 200 lbs
Net Engine Power	74 hp
Width over Tires	1, 800 mm
Height to Top of Cab	2, 300 mm
Hinge Pin Height	2, 800 mm
Travel Speed	11 km/h
Travel Speed (High)	11 km/h