jcb 215 Service Manual

93 - 1
Hub-Dismantling & Assembly
The procedures for dismantling and assembling the hub on a
PD70 axle are virtually the same as for a SD80 axle -
described on the previous pages (F/92-1 to F/92-4).
However, note that the wheel bearing carrier (shown as item
15 on page F/92-1) is mounted directly on to the axle arm.
Disregard references to the hub carrier (shown as item 21 on
page F/92-1).
Section F Transmission
9803/3280
Section F
93 - 1
Issue 1
Rear Axle - PD70
www.WorkshopManuals.co.uk
Purchased from www.WorkshopManuals.co.uk

jcb 215 Specifications

General

Engine Power	74 hp
Rated Operating Capacity	2, 100 lbs
Lift Path	Vertical
Tipping Load	4, 200 lbs
Net Engine Power	74 hp
Width over Tires	1, 800 mm
Height to Top of Cab	2, 300 mm
Hinge Pin Height	2, 800 mm
Travel Speed	11 km/h
Travel Speed (High)	11 km/h