host1(config)#mpls create-dynamic-interfaces ip on-major-interfaces profile
dynip
For all types of labels that are advertised for the LSR that is the egress router for the
prefix, you must complete the following steps, in addition to those detailed earlier,
on the E Series router:
1. Enable IGMP on the interface which owns the route to the source by using the
ip igmp command. Because the route to the source can change dynamically, we
recommend that you enable IGMP on all interfaces of the router or, at least, on
all interfaces that might be the next hop interface to the source.
2. Disable the multicast reverse path forwarding (RPF) check policy for all the
streams that will be delivered on the point-to-multipoint LSP by using the ip
multicast-routing disable-rpf-check command. For more information, see
Enabling and Disabling RPF Checks in the JUNOSe Multicast Routing Configuration
Guide.
Related Topics â– Point-to-Multipoint LSPs Overview on page 262
â– show mpls tunnels
266 â– Point-to-Multipoint LSPs Configuration
JUNOSe 11.1.x BGP and MPLS Configuration Guide
To Next Page
Loading...
Need help?
General
