ATM 3/0.8100 1 8100 8100 PVC SNAP UBR 0 0 0 DOWN
8000 circuit(s) found
Reserved VCC ranges:
Start Start End End
Interface VPI VCI VPI VCI
--------- ----- ----- --- ---
ATM 2/0 2 100 2 102
ATM 2/0 3 300 3 303
2 reservation(s) found
To display a summary of all reserved VC ranges on the router, including those reserved
for MPLS use:
host1#show atm vc reserved
Reserved VCC ranges:
Start Start End End
Interface VPI VCI VPI VCI
--------- ----- ----- --- ---
ATM 2/0 2 100 2 102
ATM 2/0 3 300 3 303
2 reservation(s) found
Meaning Table 33 on page 321 lists the show atm vc command output fields.
Table 33: show atm vc Output Fields
Field DescriptionField Name
Interface type and numberInterface
Virtual path identifierVPI
Virtual channel identifierVCI
Virtual circuit descriptorVCD
Type of circuit: PVCType
Encapsulation method: AUTO, AAL5, MUX, SNAP, ILMI, F4-OAMEncap
Service type configured on the VC: UBR, UBR-PCR, NRT-VBR,
RT-VBR, CBR
Category
Peak rate in KbpsRx/Tx Peak
Average rate in KbpsRx/Tx Avg
Maximum number of cells that can be burst at the peak cell rateRx/Tx Burst
State of the virtual circuit: Up, DownStatus
Starting virtual path identifier (inclusive) of the reserved VC rangeStart VPI
Starting virtual circuit identifier (inclusive) of the reserved VC rangeStart VCI
Ending virtual path identifier (inclusive) of the reserved VC rangeEnd VPI
Ending virtual circuit identifier (inclusive) of the reserved VC rangeEnd VCI
Monitoring ATM VCs and VPI/VCI Ranges Used for MPLS â– 321
Chapter 4: Monitoring MPLS
To Next Page
Loading...
Need help?
General
