There is no no version.
Clearing BGP Route Flap Dampening Information for the VPWS Address Family
To clear route flap dampening information for the VPLS address family associated
with the specified VPLS instance:
â– Issue the clear ip bgp dampening command.
host1#clear ip bgp vpls vplsA dampening
There is no no version.
Clearing the Wait for the End-of-RIB Marker for the L2VPN Address Family
To clear the wait for receiving an End-of-RIB marker from the peer for the L2VPN
address family:
â– Issue the clear ip bgp wait-end-of-rib command.
host1#clear ip bgp l2vpn wait-end-of-rib
Related Topics â– Configuring BGP Routing on page 3
â– clear ip bgp
â– clear ip bgp dampening
â– clear ip bgp wait-end-of-rib
Monitoring Bridging-Related Settings for VPLS
You can use the show commands listed in Table 84 on page 617 to display VPLS
settings related to transparent bridging. Except for the show bridge interface vpls
command, which is only for VPLS instances, you can use these commands to monitor
both VPLS instances and standard bridge groups for transparent bridging.
Table 84: Commands for Monitoring VPLS Bridging Settings
show bridge portshow bridge
show bridge tableshow bridge groups
show subscriber-policyshow bridge interface
show bridge interface vpls
Monitoring Bridging-Related Settings for VPLS â– 617
Chapter 11: Monitoring VPLS
To Next Page
Loading...
Need help?
General
