Juniper BGP - CONFIGURATION GUIDE V 11.1.X User Manual

Configuration Tasks for VPLS with BGP Signaling
To configure VPLS with BGP signaling on the PE router:
1. Configure a single instance of VPLS, known as a VPLS instance, on the PE router
for each VPLS domain in which the router participates.
2. (Optional) Configure BGP multihoming for the customer site.
3. (Optional) Configure optional attributes for the VPLS instance.
4. Configure network interfaces to connect the PE router to each CE device.
5. (Optional) Configure nondefault subscriber policies for the VPLS network interface.
6. Configure a loopback interface and assign a router ID that uses the IP address
of the loopback interface.
7. Configure MPLS label-switched paths (LSPs) to connect local and remote PE
routers.
8. Set up BGP signaling on the autonomous system configured to signal reachability
for this VPLS instance.
Related Topics ■ Configuring VPLS Instances with BGP Signaling on page 590
■ Configuring Optional Attributes for VPLS Instances on page 593
■ Configuring VPLS Network Interfaces on page 594
■ Configuring Subscriber Policies for VPLS Network Interfaces on page 595
■ Configuring the Loopback Interface and Router ID for VPLS on page 598
■ Configuring MPLS LSPs for VPLS on page 599
■ Configuring BGP Signaling for VPLS on page 600
■ See VPLS Configuration Example with BGP Signaling on page 601 for a detailed
sample configuration.
Configuring VPLS Instances with BGP Signaling
You must configure a VPLS instance for each VPLS domain in which the router
participates. From a configuration standpoint, a VPLS instance is simply a new or
existing bridge group that you configure with additional VPLS attributes.
Table 78 on page 590 lists the commands that you use to configure a basic VPLS
instance, as described in this section.
Table 78: Commands to Configure Basic VPLS Instances
bridge vpls site-rangebridge vpls rd
bridge vpls transport-virtual-routersbridge vpls route-target
590 ■ Configuration Tasks for VPLS with BGP Signaling
JUNOSe 11.1.x BGP and MPLS Configuration Guide

Juniper BGP - CONFIGURATION GUIDE V 11.1.X Specifications

General

Brand	Juniper
Model	BGP - CONFIGURATION GUIDE V 11.1.X
Category	Software
Language	English