Juniper BGP - CONFIGURATION GUIDE V 11.1.X User Manual

To set a statistics baseline for layer 2 services over MPLS:
■ Issue the baseline mpls interface command:
host1#baseline mpls interface
There is no no version.
Related Topics ■ baseline mpls interface
Monitoring ATM Martini Cell Packing Timers for Layer 2 Services over MPLS
Purpose Display the current systemwide values configured on the router for the three ATM
Martini cell packing timers.
The ATM Martini cell packing timers define the time threshold that the router uses
to collect and concatenate ATM cells in a single VCC cell relay–encapsulated packet.
Action To display ATM Martini cell packing timers:
host1(config)#show atm mcpt-timers
ATM Martini cell aggregation timers:
Timer1: 1500microseconds
Timer2: 2500microseconds
Timer3: 3500microseconds
Meaning Table 69 on page 564 lists the show atm mcpt-timers command output fields
Table 69: show atm mcpt-timers Output Fields
Field DescriptionField Name
Value in microseconds for the first ATM Martini cell packing timerTimer1
Value in microseconds for the second ATM Martini cell packing
timer
Timer2
Value in microseconds for the third ATM Martini cell packing timerTimer3
Related Topics ■ show atm mcpt-timers
Monitoring ATM Subinterfaces for Layer 2 Services over MPLS
Purpose Display the current state of all specified ATM subinterfaces.
564 ■ Monitoring ATM Martini Cell Packing Timers for Layer 2 Services over MPLS
JUNOSe 11.1.x BGP and MPLS Configuration Guide

Juniper BGP - CONFIGURATION GUIDE V 11.1.X Specifications

General

Brand	Juniper
Model	BGP - CONFIGURATION GUIDE V 11.1.X
Category	Software
Language	English