Table 55: show mpls rsvp authentication Output Fields (continued)
Field DescriptionField Name
Sequence number of first authenticated packet from peer;
subsequent packets from the peer must be greater than this base
number
Receive Sequence Number
Related Topics â– show mpls rsvp authentication
Monitoring RSVP-TE Interfaces Where BFD is Enabled
Purpose Display information about RSVP-TE major interfaces on which BFD is enabled.
For point-to-point interfaces, this command displays a single secure association with
the single peer at the remote end. For multiaccess type interfaces (Ethernet), this
command displays, if present, multiple secure associations from the various RSVP
speakers.
Action To display information about RSVP-TE major interfaces on which BFD is enabled:
host1#show mpls rsvp bfd interfaces
Bfd Enabled RSVP interfaces
---------------------------
Minimum Minimum Minimum
Interface Interval Rx-Interval Tx-Interval Multiplier
--------- -------- ----------- ----------- ----------
ATM2/0.1 300 300 300 3
Meaning Table 56 on page 359 lists the show mpls rsvp bfd interfaces command output fields.
Table 56: show mpls rsvp bfd interfaces Output Fields
Field DescriptionField Name
RSVP-TE major interface on which BFD is enabledInterface
Minimum interval in milliseconds, used when the minimum receive
interval and minimum transmit intervals have the same value
Minimum Interval
Minimum receive interval in milliseconds; minimum interval at
which the local peer must receive BFD control packets from the
remote peer
Minimum Rx-Interval
Minimum transmit interval in milliseconds; interval at which the
local peer proposes to transmit BFD control packets to the remote
peer
Minimum Tx-Interval
Monitoring RSVP-TE Interfaces Where BFD is Enabled â– 359
Chapter 4: Monitoring MPLS
To Next Page
Loading...
Need help?
General
