Unicast : Permit
PPPoE : Permit
Relearn : Permit
Mpls : Permit
Subscriber: default Trunk
ARP : Permit
Broadcast : Permit
Multicast : Permit
Unknown Destination : Permit
IP : Permit
Unknown Protocol : Permit
Unicast : Permit
PPPoE : Permit
Relearn : Permit
Mpls : Permit
Subscriber: client01
ARP : Permit
Broadcast : Permit
Multicast : Deny
Unknown Destination : Deny
IP : Permit
Unknown Protocol : Permit
Unicast : Permit
PPPoE : Permit
Relearn : Deny
Mpls : Permit
Meaning Table 93 on page 631 lists the show subscriber-policy command output fields.
Table 93: show subscriber-policy Output Fields
Field DescriptionField Name
Name of the subscriber policySubscriber
Indicates that the subscriber interface forwards packets of the
specified type. For the relearn attribute, specifies that relearning a
MAC address entry on a different interface from the one initially
associated with this entry in the forwarding table is allowed on this
interface
Permit
Indicates that the subscriber interface filters packets of the specified
type. For the relearn attribute, specifies that relearning is prohibited
on this interface
Deny
Related Topics â– show subscriber-policy
Monitoring BGP-Related Settings for VPLS
You can use the show ip bgp commands listed in Table 94 on page 632 to display
BGP-related settings for VPLS instances in the L2VPN address family or in the VPLS
address family.
Monitoring BGP-Related Settings for VPLS â– 631
Chapter 11: Monitoring VPLS
To Next Page
Loading...
Need help?
General
