NOTE: For ATM over MPLS interfaces, the ATM-Prot field displays ATM/MPLS.
Related Topics â– show atm subinterface
Monitoring ATM Cross-Connects for Layer 2 Services over MPLS
Purpose Display all ATM cross-connects (passthrough connections between local subinterfaces).
Action To display ATM cross-connects:
host1#show mpls cross-connects atm
Cate Peak
VC-ID Encap gory Rate Interface VPI VCI Status
------ ----- ---- ---- ---------- --- --- ------
600001 AAL5 UBR 0 ATM6/0.101 0 101 Up
ATM6/2.101 0 101 Up
600002 AAL5 UBR 0 ATM6/0.102 0 102 Up
ATM6/2.102 0 102 Up
2 local connection(s) found
Meaning Table 71 on page 566 lists the show mpls cross-connects atm command output fields
Table 71: show mpls cross-connects atm Output Fields
Field DescriptionField Name
VC ID number of the connectionVC-ID
Administered encapsulation method based on what was configured
with the atm pvc command
Encap
Configured service categoryCategory
Send and receive peak rate, in KbpsPeak Rate
Specifier and status of the first subinterface that makes up the local
cross-connect
Interface
Virtual path identifier of the first subinterfaceVPI
Virtual channel identifier of the first subinterfaceVCI
Current state of the connectionStatus
566 â– Monitoring ATM Cross-Connects for Layer 2 Services over MPLS
JUNOSe 11.1.x BGP and MPLS Configuration Guide
To Next Page
Need help?
General
