Route Distinguisher (RD) is 100:23
Original Route Distinguisher (RD) is 100:23
MPLS in-label is none
MPLS in-label block size is 0
MPLS out-label is 106
MPLS out-label block size is 10
Next hop IP address is 2.2.2.2 (metric 3)
Multi-exit discriminator is not present
Local preference is 100
Weight is 0
Origin is IGP
AS path is empty
Extended communities RT:100:3 Layer2:atm-vcc-cell:use-cw,use-seq,:mtu=0
Status Vector 0x7fc0
Meaning Table 105 on page 676 lists the show ip bgp l2vpn command output fields
Table 105: show ip bgp l2vpn Output Fields
Field DescriptionField Name
IP address of the local PE routerLocal BGP identifier
Autonomous system numberlocal AS
Version number of the local routing information baseLocal-RIB version
Version number of the forwarding information baseFIB version
Status codes for the route, listed before the Prefix:
■>—best route
■*—invalid route
■s—suppressed route
■d—dampened route
■r—rejected route
■a—auto-summarized
■m—multihomed backup route
Status codes
Route prefix in the format siteID:blockOffsetPrefix
IP address of the peer from which the route was learnedPeer
IP address of the next router that is used when a packet is
forwarded to the destination network
Next-hop (or Next hop IP
address)
Multiexit discriminator for the routeMED
Local preference for the routeLocPrf
Weight of the routeWeight
Origin of the routeOrigin
AS path through which this route has been advertisedAS Path
676 â– Monitoring BGP-Related Settings for VPWS L2VPNs
JUNOSe 11.1.x BGP and MPLS Configuration Guide
To Next Page
Loading...
Need help?
General
