Juniper BGP - CONFIGURATION GUIDE V 11.1.X User Manual

To display RSVP-TE session information:
host1:two#show mpls rsvp sessions
Destination 222.9.3.1 TunnelId 1 Extended Tunnel Id 223.10.1.1
PSB: Sender 223.10.1.1 LSPId 1 timeout 157500 InLabel 17
Associated Minor Interface: Tunnel 223.10.1.1:1
PHopIntf ATM2/0.1
IncomingIntf ATM2/1.1
OutgoingIntf ATM2/0.3
PHopAddr 221.1.1.2 m_ipNextHopAddr 122.1.1.1
NextHop 122.1.1.1/255.255.255.255 (strict)
LabelRange (generic) min 0 max 1048575
SenderTSpec CType IntServ Controlled Load
Token Bucket Rate 0
Token Bucket Size 0
Peak Data Rate 0
Min Policed Unit 0
Max Packet Size 0
RRO IPv4 hop 221.1.1.2 (strict)
ADSPEC --
IN ERO IPv4 hop 221.1.1.1 (strict)
IPv4 hop 122.1.1.1 (strict)
OUT ERO IPv4 hop 122.1.1.1 (strict)
SES ATTR Setup Pri 4, Hold Pri 4, name --
Flags : IngressReRoute
TTC --
Policy Object --
Unknown Objects --
Flags : InUse
PathRefreshSent
RSB: Timeout 157500 label 16
Associated Minor Interface: Tunnel 223.10.1.1:1
FlowSpec CType IntServ Controlled Load
Token Bucket Rate 0
Token Bucket Size 0
Peak Data Rate 0
Min Policed Unit 0
Max Packet Size 0
RRO IPv4 hop 122.1.1.1 (strict)
Policy Object --
Unknown Objects --
Flags : InUse
StyleConverted
ResvRefrSent
Meaning Table 54 on page 355 lists the show mpls rsvp command output fields.
Table 54: show mpls rsvp Output Fields
Field DescriptionField Name
Path state control blockPSB
Reservation state control blockRSB
IP address of PSB or RSB senderSender
ID of LSPLSPId
Monitoring RSVP Path State Control Blocks, Reservation State Control Blocks, or Sessions ■ 355
Chapter 4: Monitoring MPLS

Juniper BGP - CONFIGURATION GUIDE V 11.1.X Specifications

General

Brand	Juniper
Model	BGP - CONFIGURATION GUIDE V 11.1.X
Category	Software
Language	English