Table 34: show cac interface Output Fields (continued)
Field DescriptionField Name
Total bandwidth in Kbps that is available to be reservedcurrent total available bw
Absolute percentages of total reservable bandwidth that trigger the
flooding of the new bandwidth value throughout the network;
flooding is triggered when bandwidth increases past any of the up
threshold values and when bandwidth decreases past any of the
down threshold values
MPLS TE flooding threshold
up/down
Weight assigned to the interface that supersedes a weight assigned
by the IGP
MPLS TE administrative
weight
32-bit value that assigns the interface to a resource class and
enables a tunnel to discriminate among interfaces by matching
against tunnel affinity bits
MPLS TE attribute flags
Bandwidth in Kbps that is available at each priority level in the
range 0–7
Available BW at 8 priority
levels
Related Topics â– show cac interface
Monitoring Virtual Router Configuration
Purpose Display the configuration of all virtual routers or a specific virtual router.
Action To display VR configuration:
host1#show configuration virtual-router euro7
Related Topics â– show configuration
Monitoring IP and IPv6 Tunnel Routing Tables
Purpose Display the current state of the IPv4 or IPv6 tunnel routing table.
Action To display information about all IP tunnel routes:
host1:vr2# show ip tunnel-route all
Protocol/Route type codes:
I1- ISIS level 1, I2- ISIS level2,
I- route type intra, IA- route type inter, E- route type external,
i- metric type internal, e- metric type external,
O- OSPF, E1- external type 1, E2- external type2,
N1- NSSA external type1, N2- NSSA external type2
L- MPLS label, V- VRF, *- via indirect next-hop
Monitoring Virtual Router Configuration â– 323
Chapter 4: Monitoring MPLS
To Next Page
Loading...
Need help?
General
