Table 109: show l2vpn interface Output Fields (continued)
Field DescriptionField Name
Name of the VPWS instance to which the interface belongsMember of L2VPN instance
Local customer site ID configured on the interfaceLocal site ID
Remote customer site ID configured on the interfaceRemote site ID
Local preference for the control word, preferred or not preferredControl word
Local preference for sequence numbers, send or don’t sendsend sequence numbers
Type of signaling and encapsulation used by the router for layer 2
traffic
Relay format
Administrative state of the interface, enabled or disabledAdministrative state
Operational state of the interface, up or downOperational state
Maximum allowable size in bytes of the maximum transmission
unit for the interface
Operational MTU
UID automatically assigned to the MPLS shim interface when it is
created
MPLS shim interface UID
UID automatically assigned to the MPLS major interface when it is
created
Lower interface UID
Internal, platform-dependent, 32-bit representation of the interface
location, used by Juniper Networks Customer support for
troubleshooting.
Condensed location
Number of packets, bytes, errors and discards received on the
interface
Received
Number of packets, bytes, errors and discards sent from the
interface
Sent
Number of messages queued to be sent on the interfacequeue
Type of traffic class configured for traffic on the interfacetraffic-class
ATM virtual circuit to which the interface is boundbound to
Length of all messages queued to be sent to on this connection, in
bytes
Queue length
Number of packets and bytes that have been forwardedForwarded
Number of committed packets and bytes that have been droppedDropped committed
Number of conformed packets and bytes that have been droppedDropped conformed
packets
Number of exceeded packets and bytes that have been droppedDropped exceeded
Monitoring L2VPN Interfaces for VPWS â– 685
Chapter 14: Monitoring VPWS
To Next Page
Need help?
General
