Juniper EX Series Complete Hardware Guide

Packing EX-series Switch Components for Shipping
CAUTION: Do not stack switch components. Return individual components in separate
boxes if they do not fit together on one level in the shipping box.
To pack and ship EX-series switch components:
■ Place individual boards in electrostatic bags.
■ Ensure that the components are adequately protected with packing materials
and packed so that the pieces are prevented from moving around inside the
carton.
■ Securely tape the box closed.
■ Write the RMA number on the exterior of the box to ensure proper tracking.
Related Topics ■ Returning an EX-series Switch or Component for Repair or
Replacement on page 117
122 ■ Packing EX-series Switch Components for Shipping
Complete Hardware Guide for EX 3200 and EX 4200 Switches

Juniper EX Series Specifications

General

Series	EX Series
Category	Switch
Layer	Layer 2/3
Operating System	Junos OS
Managed	Yes
ACLs	Yes
Port Density	Varies by model
Power over Ethernet (PoE)	Available on some models
Virtual Chassis	Supported on some models
Form Factor	Fixed configuration, Modular
Switching Capacity	Varies by model
Forwarding Rate	Varies by model
Power Supply	Varies by model (AC or DC, redundant options available)
Management	CLI, Web UI, SNMP
Redundancy	Power supply, fan, Virtual Chassis
Latency	Varies by model
Jumbo Frames	Supported
VLAN Support	Yes
MAC Address Table Size	Varies by model
QoS	Yes
Energy Efficiency	EEE (802.3az)
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	0° to 45° C
Storage Temperature	-40° to 70° C
Humidity	5% to 90% non-condensing
MTBF	Varies by model
Warranty	Limited Lifetime