To Next Page

To Previous Page

NOTE: EX2200 switches with DC power supply do not provide PoE.

NOTE: For DC power supplies, we recommend that you provide at least 3.5 A

at 48 VDC and use a facility circuit breaker rated for 10 A minimum. Doing so

enables you to operate the switch in any configuration without upgrading

the power infrastructure, and allows the switch to function at full capacity

using multiple power supplies.

Documentation

AC Power Cord Specifications for EX2200 Switches on page 66•

• Power Supply in EX2200 Switches on page 18

• General Safety Guidelines and Warnings on page 155

• General Electrical Safety Guidelines and Warnings on page 179

AC Power Cord Specifications for EX2200 Switches

A detachable AC power cord is supplied with the AC power supplies. The coupler is type

C13 as described by International Electrotechnical Commission (IEC) standard 60320.

The plug at the male end of the power cord fits into the power source outlet that is

standard for your geographical location.

CAUTION: The AC power cord provided with each power supply is intended

for use with that power supply only and not for any other use.

NOTE: In North America, AC power cords must not exceed 4.5 meters

(approximately 14.75 feet) in length, to comply with National Electrical Code

(NEC) Sections 400-8 (NFPA 75, 5-2.2) and 210-52 and Canadian Electrical

Code (CEC) Section 4-010(3). The cords supplied with the switch are in

compliance.

Table 24 on page 66 lists AC power cord specifications provided for each country or

region.

Table 24: AC Power Cord Specifications

Plug TypePlug StandardsElectrical SpecificationsCountry/Region

RA/3IRAM 2073250 VAC, 10 A, 50 HzArgentina

SAA/3AS/NZZS 3112250 VAC, 10 A, 50 HzAustralia

BR/3NBR 14136250 VAC, 10 A, 50 HzBrazil

Complete Hardware Guide for EX2200 Ethernet Switches

Juniper EX2200 Series User Manual

Questions and Answers: