6. Slide the switch chassis to the left or right a bit so that the mounting screws are pushed
into the channels of the holes on the bottom panel until the switch locks firmly in
place as shown in Figure 44 on page 144.
Figure 44: Mounting an EX2300-C Switch on a Wall
7. (Optional) Attach the optional standard cable lock to the security slot on the side of
the switch:
a. Fasten the cable to a desk or a rack and set the lock to the unlocked position.
b. Insert the lock into the security slot on your chassis and set the lock to the locked
position using the key. See Figure 45 on page 144.
Figure 45: Securing the EX2300-C Switch by Using the Security Slot
Mounting an EX2300 Switch Except the EX2300-C Switch on a Wall
You can mount an EX2300 switch on a wall by using theseparatelyorderable wall-mount
kit.
Before mounting the switch on a wall:
Copyright © 2017, Juniper Networks, Inc.144
EX2300-C and EX2300 Switches Hardware Guide