CHAPTER 4
Power Supplies
•
Power Supply in EX2300 Switches on page 27
Power Supply in EX2300 Switches
The power supply in EX2300 switches is built in along the rear panel of the chassis, with
an AC power cord inlet or DC power terminals on the rear panel to connect power to the
switch.
NOTE: After powering on the switch, wait for at least 60 seconds before
powering it off. After powering off the switch, wait for at least 60 seconds
before powering it back on.
Table 12 on page 27 lists the power consumed by each EX2300 switch model.
Table 12: Power Consumed by EX2300 Switches
Maximum PoE/PoE+
Power Available
Maximum Power
Consumed by the Switch
Number of PoE-Enabled
PortsModel Number
–20 W–EX2300-C-12T
124 W24 W (when no PoE power is
drawn)
12EX2300-C-12P
–55 W–EX2300-24T
370 W80 W (when no PoE power is
drawn)
24EX2300-24P
–55 W–EX2300-24T-DC
–76 W–EX2300-48T
405 W91 W (when no PoE power is
drawn
48EX2300-48P
27Copyright © 2017, Juniper Networks, Inc.