To Next Page

To Previous Page

RELATED DOCUMENTATION

QFX5200 Power System | 39

QFX5200 Power Cord Specicaons | 43

Performing the Inial Soware Conguraon for

QFX5200 Switches

Before you begin connecng and conguring a QFX5200, set the following parameter values on the

console server or PC:

• Baud Rate—9600

• Flow Control—None

• Data—8

• Parity—None

• Stop Bits—1

• DCD State—Disregard

You must perform the inial conguraon of the QFX5200 through the console port using the CLI or

through Zero Touch Provisioning (ZTP). In order to use ZTP to provision the device, you must have

access to a Dynamic Host Control Protocol (DHCP) server, and a File Transfer Protocol (anonymous

FTP), Hypertext Transfer Protocol (HTTP), or Trivial File Transfer Protocol (TFTP) server on which the

soware image and conguraon les are stored. For more informaon about using ZTP for provisioning

the device, see Understanding Zero Touch Provisioning in the

Installaon and Upgrade Guide

To connect and congure the switch from the console:

1. Connect the console port to a laptop or PC using the supplied RJ-45 cable and RJ-45 to DB-9

adapter. The console (CON) port is located on the management panel of the switch.

2. Log in as root. There is no password. If the soware booted before you connected to the console

port, you might need to press the Enter key for the prompt to appear.

122

Juniper QFX5200 User Manual

Questions and Answers: