Changing the Reset Config Button Behavior on the SRX240 Services Gateway
You can change the default operation of the RESET CONFIG button by limiting how the
button resets the services gateway:
•
To prevent the RESET CONFIG button from setting the device to the factory-default
configuration and deleting all other configurations:
admin@host# set chassis config-button no-clear
You can still press and quickly release the button to reset it to the rescue configuration.
•
To prevent the RESET CONFIG button from setting the device to the rescue
configuration:
admin@host# set chassis config-button no-rescue
You can still press and hold the button for 15 seconds or more to reset the gateway to
the factory-default configuration.
•
To disable the button and prevent the device from resetting to either configuration:
admin@host# set chassis config-button no-clear no-rescue
The no-clear option prevents the RESET CONFIG button from deleting all configurations
on the services gateway. The no-rescue option prevents the RESET CONFIG button from
loading the rescue configuration.
To return the function of the RESET CONFIG button to its default behavior, remove the
config-button statement from the device configuration.
Related
Documentation
Monitoring the SRX240 Services Gateway Chassis Using the CLI on page 111•
• Monitoring the SRX240 Services Gateway Components Using LEDs on page 107
• SRX240 Services Gateway LEDs on page 18
• Loading the Rescue Configuration on the SRX240 Services Gateway on page 117
Juniper Networks Technical Assistance Center
If you need assistance while troubleshooting a services gateway, open a support case
using the Case Manager link at http://www.juniper.net/support/ , or call 1-888-314-JTAC
(within the United States) or 1-408-745-9500 (from outside the United States).
Related
Documentation
• Information You Might Need to Supply to Juniper Networks Technical Assistance Center
on page 127
Copyright © 2015, Juniper Networks, Inc.118
SRX240 Services Gateway Hardware Guide