CHAPTER 13
Connecting the SRX240 Services Gateway
to External Devices
•
Connecting and Organizing Interface Cables to the SRX240 Services
Gateway on page 63
•
Connecting the Modem at the SRX240 Services Gateway End on page 64
•
Connecting the Modem to the Console Port on the SRX240 Services
Gateway on page 65
•
Connecting to the CLI at the User End for the SRX240 Services Gateway on page 66
Connecting and Organizing Interface Cables to the SRX240 Services Gateway
You connect the interfaces installed in the services gateway to various network media.
Each type of interface on a services gateway uses a particular medium to transmit data.
You must configure each network interface before it can operate on the device.
To connect the interface cable to the device:
1. Have ready a length of the type of cable used by the interface.
2. Insert the cable connector into the cable connector port on the interface faceplate.
3. Arrange network cables as follows to prevent them from dislodging or developing
stress points:
•
Secure cables so that they are not supporting their own weight as they hang to the
floor.
•
Place excess cable out of the way in neatly coiled loops.
•
Use fasteners to maintain the shape of cable loops.
Related
Documentation
Installing the SRX240 Services Gateway on page 53•
• Grounding the SRX240 Services Gateway on page 60
• Connecting the SRX240 Services Gateway to the AC Power Source on page 69
• Powering On and Powering Off the SRX240 Services Gateway on page 74
63Copyright © 2015, Juniper Networks, Inc.
To Next Page
Loading...
Need help?
General
