KEB COMBIVERT F5 Servo User Manual

6
55
KEB COMBIVERT F5
Name: Basis
04.05.04
6
Section PageDate
© KEB Antriebstechnik, 2002
All rights reserved
Chapter
Functional DescriptionU/f-Characteristic Adjustment
250 V
190 V
CP.17=230 V
CP.16=50 Hz
U
N
/U
A
f
uF.9 = 230V
uF.0 = 50Hz
6.5.5 Voltage
Stabilization
(uF.9)
Due to fluctuations of the mains voltage or the load the DC-link voltage and with it the
directly dependent output voltage can change. In the case of enabled voltage
stabilization the fluctuations of the output voltage are compensated. That means 100%
output voltage correspond to the value adjusted in uF.9, but maximally 110 % · (DC-
link voltage / √ 2 ). Furthermore, this function makes it possible to adapt motors with
a smaller rated current to the inverter.
uF.9 = 1...649 V
650 = off (default)
Fig. 6.5.5.a Voltage stabilization
with voltage stabilization
without voltage stabilization
Fig. 6.5.5.b Example: Acceleration with load
Load
Load
Motor voltage
Motor speed
Motor voltage
Motord speed
U
A
bei U
N
= 250V unstabilized
U
A
bei U
N
= 190V unstablized
U
A
bei U
N
= 190V stablized
U
A
bei U
N
= 250V stabilized
Example:uF.9 = 230V
no Boost is adjusted
U
N
= Mains voltage
U
A
= Output voltage
Voltage stabilization
PT1-time constant
(uF.19)
(only for F5-G >= D-housing)
With uF.19 the time constant of a PT1-element is defined. The PT1-element serves for
the smoothing of the DC-link voltage. The initial value of the PT1-element is used as
actual value for the voltage stabilization.
uF.19 PT1-time constant
0 Function off
12ms
24ms
38ms
416ms
532ms
664ms
7 128 ms
8 256 ms
9 512 ms
10 1024 ms

KEB COMBIVERT F5 Servo Specifications

General

Brand	KEB
Model	COMBIVERT F5 Servo
Category	DC Drives
Language	English