DISPlay, FORMat, and SYSTem 16-9
A) SYSTem:PRESet
Returns the instrument to states optimized for front panel operation. SYSTem:PRESet
defaults are listed in the SCPI tables in Section 17.
B) SYSTem:TIME:RESet
Resets the absolute timestamp to 0 seconds. The timestamp also resets when power is cycled,
or after the instrument is on for 99,999.99 seconds. The TRACe:TSTamp:FORMat command is
used to select the absolute timestamp. See Section 8 (Buffer) for details.
C) SYSTem:POSetup <name>
Parameters RST Power-up to *RST defaults
PRESet Power-up to SYSTem:PRESet defaults
SAVx Power-up to setup stored in memory (x = memory location 0,
1, 2, 3 or 4)
The *RST and SYSTem:DEFaults are listed in the SCPI tables in the Section 17. A setup is
saved in memory using the *SAV command. See Section 14 (Common Commands) for details.
D) SYSTem:VERSion
Read the version of the SCPI standard being used by Model 6514. Example response mes-
sage: 1996.0.
E) SYSTem:KEY <NRf>
Parameters 1 = SHIFT key 17 = LOCAL key
2 = V key 18 = AVG key
3 = I key 19 = MEDIAN key
4 = Ω key 20 = REL key
5= Q key 21 = LIMIT key
6 = XFDBK key 22 = DIGIT key
7 = ZCHECK key 23 = RATE key
8 = ZCOR key 24 = Cursor left arrow key
9 = ------- 25 = -------
10 = ------- 26 = STORE key
11 = RANGE up arrow key 27 = RECALL key
12 = AUTO key 28 = DELAY key
13 = RANGE down arrow key 29 = DAMP key
14 = ENTER key 30 = HALT key
15 = Cursor right arrow key 31 = TRIG key
16 = GRD key 32 = EXIT key
To Next Page
Loading...
Need help?
General
