17-4 SCPI Reference Tables
Command Description
Default
parameter
Ref SCPI
:SOURce2? Query output pattern value. √
:STATe <b> Enable or disable limit 2 test. OFF √
:STATe? Query state of limit 2 test. √
:FAIL? Return result of limit 2 test; 0 (pass) or 1 (fail). √
:CLIMits Composite Limits:
:CLEar Clear I/O port and restore it back to
SOURce2:TTL settings:
[:IMMediate] Clears I/O port immediately.
:AUTO <b> When enabled, I/O port clears when :INITiate
sent.
ON
:AUTO? Query state of auto-clear.
:PASS Define “pass” digital output pattern.
:SOURce2 <NDN> or
<NRf>
Specify 4-bit pass pattern (no failures). 15
:SOURce2? Query “pass” output pattern.
:NULL Configure and control Rel: √
:ACQuire Use input signal as Rel value.
:OFFSet <NRf> Specify Rel value; -9.999999e20 to
9.999999e20.
0.0 √
:OFFSet? Query Rel value. √
:STATe <b> Enable or disable Rel. OFF √
:STATe? Query state of Rel. √
:DATA? Return all CALC2 readings triggered by INITiate. √
:LATest? Return only the last (latest) reading.
:CALCulate3 Path to configure and control CALC3 calculations
on buffer data:
Sec 8 √
:FORMat <name> Select buffer statistic; MEAN, SDEViation,
Maximum, MINimum or PKPK.
MEAN √
:FORMat? Query selected statistic. √
:DATA? Read the selected buffer statistic. √
:SOURce2 <NDN> and <NRf> parameters:
<NDN> = #Bxxxx Binary format (each x = 1 or 0)
= #Hx Hexadecimal format (x = 0 to F)
= #Qxx Octal format (x = 0 to 17)
<NRf> = 0 to 15 Decimal format
Table 17-1 (cont.)
CALCulate command summary
To Next Page
Loading...
Need help?
General
