9 SERVICE SCHEDULE
26
9.1 Additional information
Any further work that results from the compulsory work or from the recommended work must be ordered sepa-
rately and invoiced separately.
Different service intervals may apply in your country, depending on the local operating conditions.
Individual service intervals and scopes may change in the course of technical developments. The most up-to-date
service schedule can always be found on KTM Dealer.net. Your authorized KTM dealer will be happy to advise
you.
9.2 Required work
Every 80 operating hours
Every 40 operating hours
Every 20 operating hours
After 10 operating hours
Check the front brake linings. ( p. 75) ○ ● ● ●
Check the brake linings of the rear brake. ( p. 82) ○ ● ● ●
Check the brake discs. ( p. 72) ○ ● ● ●
Check the brake lines for damage and leakage. ○ ● ● ●
Change the foot brake cylinder sealing cup. ● ● ●
Check the rear brake fluid level. ( p. 80) ○ ● ● ●
Check the free travel of the foot brake lever. ( p. 78) ○ ● ● ●
Check the frame. ( p. 69) ● ● ●
Check the link fork. ( p. 69) ● ● ●
Check the fork bearing for play. ● ● ●
Check the shock absorber heim joint for play. ● ● ●
Check the tire condition. ( p. 91) ○ ● ● ●
Check tire pressure. ( p. 92) ○ ● ● ●
Check the wheel bearing for play. ● ● ●
Check the wheel hubs. ● ● ●
Check the rim run-out. ○ ● ● ●
Check the spoke tension. ( p. 93) ○ ● ● ●
Check the chain, rear sprocket, engine sprocket, and chain guide. ( p. 65) ○ ● ● ●
Check the chain tension. ( p. 63) ○ ● ● ●
Grease all moving parts (e.g., hand lever, chain, ...) and check for smooth operation. ○ ● ● ●
Check the front brake fluid level. ( p. 73) ○ ● ● ●
Check the play of the handbrake lever. ( p. 71) ○ ● ● ●
Check the steering head bearing play. ( p. 49) ○ ● ● ●
Change the spark plug and spark plug connector. ● ● ●
Change the gear oil. ( p. 111) ○ ● ●
Check the gear oil level. ( p. 110) ●
Check all hoses (e.g. fuel, cooling, bleeder, drainage, etc.) and sleeves for cracking, leaks,
and incorrect routing.
○ ● ● ●
Check the antifreeze and coolant level. ( p. 94) ○ ● ● ●
Check the cables for damage and routing without sharp bends. ○ ● ● ●
Check that the throttle cables are undamaged, routed without sharp bends, and set correctly. ○ ● ● ●
Clean the air filter and air filter box. ( p. 58) ○ ● ● ●
Change the glass fiber yarn filling of the main silencer. ( p. 59) ● ● ●
To Next Page
Loading...
Need help?
General
