TUNING THE CHASSIS 10
37
Info
This is due to the volume of the hose and not due to a
defect in the fork airpump or the fork.
Read the accompanying KTM PowerParts instructions.
– Adjust the air pressure as specified.
Guideline
Air pressure 2 bar (29 psi)
Gradual changing of the air
pressure in steps of
0.2 bar (3 psi)
Minimum air pressure 1.4 bar (20 psi)
Maximum air pressure 4 bar (58 psi)
Info
Never adjust the air pressure to a value outside the
stated range.
– Disconnect the fork airpump from the left fork leg.
When disconnecting, excess pressure will escape from the
hose – the fork leg itself does not lose any air.
The fork airpump indicator switches off automatically after
80 seconds.
– Mount the protection cap.
Info
Only mount the protection cap by hand.
Finishing work
– Remove the motorcycle from the lift stand. ( p. 40)
10.14 Adjusting the rebound damping of the fork (50 SX, FACTORY EDITION)
Info
The hydraulic rebound damping determines the fork suspension behavior.
F02189-10
–
Turn adjuster
1
clockwise all the way.
Info
Adjuster
1
is located at the upper end of the right
fork leg.
– Turn counterclockwise by the number of clicks corresponding
to the fork type.
Guideline
Rebound damping
Comfort 15 clicks
Standard 12 clicks
Sport 10 clicks
To Next Page
Loading...
Need help?
General
