COMBINATION INSTRUMENT 7
53
Warning
Danger of accidents When visibility is poor, the day-
time running light is not a substitute for the low beam.
Automatic switching between the daytime running
light and low beam may only be partially available
when visibility is significantly impaired due to fog,
snow or rain.
– Ensure that the appropriate type of lighting is
always selected.
– If necessary switch off the daytime running lights
using the menu before going on a ride or when
stopped so that the low beam is switched on per-
manently.
– Make sure that the daytime running light is deac-
tivated with the diagnostics tool when the menu
item is not available, but the low beam is required.
(Your authorized KTM workshop will be glad to
help.)
– Note the legal regulations regarding the daytime
running light.
– Activate the menu item using the UP or DOWN button.
– Press the SET button to switch the daytime running light on or
off.
7.24.37 Units
F01822-01
Condition
• The motorcycle is stationary.
– Press the SET button when the menu is closed.
– Press the UP or DOWN button until Settings is marked. Press
the SET button to open the menu.
– Press the UP or DOWN button until Units is marked. Press
the SET button to open the submenu.
The Units submenu allows settings to be made for units or various
values.
7.24.38 Distance
F01823-01
Condition
• The motorcycle is stationary.
– Press the SET button when the menu is closed.
– Press the UP or DOWN button until Settings is marked. Press
the SET button to open the menu.
– Press the UP or DOWN button until Units is marked. Press
the SET button to open the submenu.
– Press the UP or DOWN button until Distance is marked. Press
the SET button to open the submenu.
– Activate the menu item using the UP or DOWN button.
– Press the SET button to confirm the desired unit.
To Next Page
Loading...
Need help?
General
