RIDING INSTRUCTIONS 10
69
10.6 Applying the brakes
Warning
Danger of accidents Moisture and dirt impair the brake system.
– Brake carefully several times to dry out and remove dirt from the brake linings and the brake discs.
Warning
Danger of accidents A spongy pressure point on the front or rear brake reduces braking efficiency.
– Check the brake system and do not continue riding until the problem is eliminated. (Your authorized
KTM workshop will be glad to help.)
Warning
Danger of accidents The brake system fails in the event of overheating.
If the foot brake lever is not released, the brake linings drag continuously.
– Take your foot off the foot brake lever if you do not want to brake.
Warning
Danger of accidents Higher total weight increases the stopping distance.
– Take the longer stopping distance into account when carrying a passenger or luggage with you.
Warning
Danger of accidents Salt on the roads impairs the brake system.
– Brake carefully several times to remove salt from the brake linings and the brake discs.
Warning
Danger of accidents ABS may increase the stopping distance in certain situations.
– Adjust application of the brakes to the respective riding situation and riding surface conditions.
Warning
Danger of accidents Excessively forceful application of the brakes blocks the wheels.
The ABS effectiveness is only ensured if it is switched on.
– Leave the ABS switched on in order to benefit from the protective effect.
Warning
Danger of accidents The rear wheel can lock due to the engine braking effect.
– Pull in the clutch, if you perform emergency or full braking, or if you brake on a slippery ground.
Warning
Danger of accidents Driving aids can reduce the probability of a fall only within physical limits.
It is not always possible to compensate for extreme riding situations, for example with luggage loaded
with a high center of gravity, varying road surfaces, steep descents or full braking without disengaging
the gear.
– Adapt your riding style to the road conditions and your driving ability.
– When braking, release the throttle and apply the front and rear brakes at the same time.
Info
When the ABS is enabled, maximum braking power can be achieved even with low road grip surfaces
such as sandy, wet, or slippery terrain without locking the wheels.
To Next Page
Loading...
Need help?
General
