Kubota K008-5 User Manual

Maintenance
W9215-8135-1 143
06/2021
Battery - change
 Open the engine hood (page 112).
 Remove the negative terminal cover and take off the cable clamp. Move the clamp to the side so as to avoid
contact with the negative terminal.
 Remove the positive terminal cover and take off the cable clamp. Move the clamp to the side so as to avoid
contact with the positive terminal.
 Remove the battery retainer and lift the battery out of the swivel frame.
 Before installation, cover the battery terminals and cable clamps with petroleum jelly.
 Install the battery in the swivel frame and fasten it with the battery retainer. Make sure that the battery is in-
stalled tightly  Do not operate the excavator with a loose battery.
 Connect the positive cable clamp to the positive terminal (+) of the battery, install the positive terminal cover.
 Connect the negative terminal (-) of the battery, install the negative terminal cover.
 Close the engine hood and secure it with a padlock.
When disconnecting and connecting the battery, always observe the specified order  Risk of short
circuit.
When replacing the battery, always install a battery of the same type with the same power rating and
the same dimensions.
STOP

Kubota K008-5 Specifications

General

Make	Kubota
Model	K008-5
Category	Compact Excavator
Bucket Capacity	0.022 m³
Max Dig Depth	1720 mm
Max Dump Height	2.43 m
Overall Length	2.75 m
Overall Width	700 mm
Fuel Tank Capacity	12 L