Operation
W9215-8135-1 77
06/2021
In order to familiarise yourself with the field of view, check the field of view (1 and 2) for a clear line of sight
from your own seated position.
Starting and stopping the engine
The obscured areas in the previous figure were determined using a field of view test method based
on the performance criteria from ISO 5006:2017.
If structural modifications to the machine restrict the defined visibility conditions, then the machine
operator must carry out a new risk assessment for the changed visibility conditions. The operator can
use the “Field of view” section in these operating instructions as a reference for the new risk assess-
ment.
Make sure that there are no persons within the machine's danger area. It is essential to warn persons
in the vicinity of the machine by briefly honking the horn.
Make sure that all operational controls are in neutral position. Also make sure the control levers are
locked.
Starting and stopping the machine is only allowed when the operator is sitting on the operator's seat.
To Next Page
Loading...
Need help?
General
